Question/Problem

 Adding Length validation to only accept a certain barcode length, to PWM

Environment

-PWM

 

Answer/Solution

 

 Under PWM -> DPC Configuration :

select the "Tray Id Suffix"
select '<', it will appear in the left box.
 select the "Tray Id Suffix" and insert "12"
Save.

Site to have tote with invalid lengths to scan. Expect "INVALID TOTE LENGTH" returned to the user. User has to scan again.

Related items

 

 

Internal Notes

 

 

 

Reason for confidentiality

 

DISCLAIMER:

Information in this document is subject to change without notice and does not represent a commitment on the part of Intelligrated. This information is typical of the questions and general advice given; however, your particular case and circumstances may produce different results or require different recommendations. Therefore, use of this information is not a suitable replacement for contacting Intelligrated Technical Service engineering for specific recommendations and solutions to your application.

 

No part of this article may be reproduced or transmitted in any form or by any means including recording, or information storage and retrieval systems, for any purpose without the express written permission of Intelligrated. All information contained within the article is private and confidential and the sole property of Intelligrated.

 

In no event, shall Intelligrated be liable for any damages whatsoever including, without limitation, damages for loss of business profits, business interruption, loss of business information, or other pecuniary loss, even if Intelligrated has been advised of the possibility of such damages. Because some states do not allow the exclusion or limitation of liability for consequential or incidental damages, the above limitation may not apply to you.

 

Template updated 2022-09-20 kwk Pending approval