Article: KB-11161
How to:
Updating the Destinations in the WES Momentum UI
Skill required to complete this article: Software ~ WCS and level is No Skill Level Association.

Question/Problem
 
How can I update destinations using the WES interface?
 
Environment

  • WCS
  • WES
  • Momemtum

 
Answer/Solution

  1. How can I enable and enable diverts SINGLE01 and SINGLE02 from scanner 18015?

    From the diverts screen in Momentum you can filter for any divert I use the scanner id 18015 and then click on single01 and then click enable in top right corner. I then did the same for single02 , both are now enabled and should be allowing diverts. 

2.  How can I make singles divert to MULTI01?

   Go to the destinations screen in Momentum and add MULTIS01 to singles by filtering for singles and then clicking edit and then adding multis01 and a divert to use for singles.

Once this is added disable SINGLES01 and SINGLES02 and singles should now be routed to MULTIS01.




DISCLAIMER:

Information in this document is subject to change without notice and does not represent a commitment on the part of Intelligrated. This information is typical of the questions and general advice given; however, your particular case and circumstances may produce different results or require different recommendations. Therefore, use of this information is not a suitable replacement for contacting Intelligrated Technical Service engineering for specific recommendations and solutions to your application.

 

No part of this article may be reproduced or transmitted in any form or by any means including recording, or information storage and retrieval systems, for any purpose without the express written permission of Intelligrated. All information contained within the article is private and confidential and the sole property of Intelligrated.

 

In no event, shall Intelligrated be liable for any damages whatsoever including, without limitation, damages for loss of business profits, business interruption, loss of business information, or other pecuniary loss, even if Intelligrated has been advised of the possibility of such damages. Because some states do not allow the exclusion or limitation of liability for consequential or incidental damages, the above limitation may not apply to you.

 

 Related Articles
No Related Articles Available.
 Help us improve this article...
What did you think of this article?
poor   excellent
Your Email:
Tell us why you rated the content this way. (optional)
RadEditor - HTML WYSIWYG Editor. MS Word-like content editing experience thanks to a rich set of formatting tools, dropdowns, dialogs, system modules and built-in spell-check.
RadEditor's components - toolbar, content area, modes and modules
   
Toolbar's wrapper 
 
Content area wrapper
RadEditor's bottom area: Design, Html and Preview modes, Statistics module and resize handle.
It contains RadEditor's Modes/views (HTML, Design and Preview), Statistics and Resizer
Editor Mode buttonsStatistics moduleEditor resizer
 
 
RadEditor's Modules - special tools used to provide extra information such as Tag Inspector, Real Time HTML Viewer, Tag Properties and other.
   
 

 Comments...
No user comments available for this article.
Published on 1/12/2022.
Last Modified on 1/12/2022.
Last Modified by Chad Bauer.
Article has been viewed 750 times.
Rated out 0 of 10 based on 0 votes.
Print Article Print Article
Print Article Email Article