Question/Problem
How is the speed for a sorter changed?
Environment
Answer/Solution
Sorter speed is located in a tab labelled "System Speed Selection"*, typically in the Command Center section. For the desired sorter, make sure that the appropriate Control Panels are stopped, then select the new speed for that sorter. The Control Panels can then be started, followed by starting the sorter and merge.
*Note that tab names in ICW can be customized to suit the individual site needs and naming conventions.

DISCLAIMER:
Information in this document is
subject to change without notice and does not represent a commitment on the
part of Intelligrated. This information is typical of the questions and general
advice given; however, your particular case and
circumstances may produce different results or require different
recommendations. Therefore, use of this information is not a suitable
replacement for contacting Intelligrated Technical Service engineering for
specific recommendations and solutions to your application.
No part of this article may be
reproduced or transmitted in any form or by any means including recording, or
information storage and retrieval systems, for any purpose without the express
written permission of Intelligrated. All information contained within the
article is private and confidential and the sole property of Intelligrated.
In no event, shall Intelligrated be
liable for any damages whatsoever including, without limitation, damages for
loss of business profits, business interruption, loss of business information,
or other pecuniary loss, even if Intelligrated has been advised of the
possibility of such damages. Because some states do not allow the exclusion or
limitation of liability for consequential or incidental damages, the above limitation
may not apply to you.